PCM Theory and Audio Reduction Codecs and Techniques Research Paper

PCM Theory and Audio Reduction Codecs and Techniques - Research Paper ExampleInstead, compressed PCM variants are normally employed. However, numerous Blu-ray format movies use the uncompressed the PCM for speech sound. Frequently, PCM convert enables digital transmission from a point to another (in a certain system, or geographically) in a serial form. However, due to the computer and digital mesh communications advancements, a lot of information or data is transmitted using the pulse wave modulation technique. Pulse wave modulation may be used to transmit analog audio show or information with a particular tramp to sample analog sign up - this rate is what is called the transmission rate. On the receiver, the delivered signal is demodulated by the Pulse-code modulation (PCM) demodulator to recuperate the original end little analog signal wave. Generally, PCM throw out be classified as a pulse amplitude modulation (PAM), pulse position modulation (PPM), pulse code modulation (PCM), and pulse width modulation (PWM). PAM, PPM, and PWM modulations are consort to analog modulation while the PCM modulation is affiliated to digital modulation. It is important to take note that PCM modulation is a real digital signal which can be processed and digitally stored by a computer. However, PPM, PWM, and PAM modulations are similar to PM, FM, and AM modulations, respectively (Aksoy & DeNardis, 2007, p. 112). For all pulse wave modulation, before the modulation, the original continuous form signal has to be sampled and the sampling rate for the sampling signal must not below, otherwise, the recovered signal will bring about distortion. The sampling rate is subject to the sampling theorem, whereby the sampling theorem states that for a pulse wave modulation system, in the condition that the sampling rate excesses the double or more(prenominal) maximum frequency times of the signal, then distortion level of data recovery on the receiver will be its minimum. For inst ance, the frequency range of the audio signal is about 40 Hz 4 kHz, the pulse wave modulation sampling signal frequency must be no less than 8 kHz, hence, the sampling error is reduced to the minimum (Maes & Vercammen, 2012, p. 67). During transmission, it is hard for the PCM signal to avoid noise distortion. Therefore, before the PCM signal sends to the PCM demodulator, a comparator is used to recover the PCM signal to its original level. The signal is a pulse wave signal series, so, before demodulating, the pulse wave signal series will be converted to a parallel digital signal by aid of a serial to a parallel converter After that, the signal passes through n-bits decoder (which should be D/A converter) for recovery of the digital signal to its original quantization value. However, in this quantization value includes not only the original audio signal alone, but also many high-frequency harmonics, hence a low-pass filter is used to remove the undesirable signal at the final fragm ent. MPEG varieties The MPEG standards comprise of different Parts.